Preparations - fitting outer races of the bearing and sealing in the link
Use this procedure to fit the outer races of the bearings in the link.
The figure shows parts and press tool placed in the link, ready to start to press the
parts.
xx1100000023
Radial sealing with dust lip D=120 mm/140 mm, T=13 mmA
Bearing, outer race (2 pcs)B
Mandrel, bearing and sealC
Guide (2 pcs)D
LinkE
Pressring, bearingF
DistanceG
Hydraulic cylinderH
Connecting rodJ
Stop nut M16 D=80 mm, T=20 mmK
NoteAction
Put the link on a workbench.1
Continues on next page
248 Product manual - IRB 760
3HAC039838-001 Revision: M
© Copyright 2011-2018 ABB. All rights reserved.
4 Repair
4.4.6 Replacement of linkage - link
Continued
To Next Page
Loading...
