ABB IRB 760 Series - Page 249

NoteAction
Check that the parts and the tool are ap-
plied correctly, as shown in the previous
figure.
Apply outer races and radial sealing with
dust lip on the pressing tool in following or-
der:
1 radial sealing wit dust lip
2 outer race
3 link
4 outer race
2
Replace the radial sealing if needed!
Art.no. is specified in Required equipment
on page 244
Use the pressing tool and fit the outer rings
and sealing.
3
Press tool link
The figure shows how to use the press tool link.
A B C
D
F
G
E
H J K L
xx1100000038
ShaftA
Support ringB
LinkC
Radial sealing with dust lip D=120/140 mm, T=13 mmD
Tapered roller bearing (2 pcs)E
Auxiliary shaftF
Press housingG
Distance, fitted on hydraulic cylinder with M6x15 screws (2 pcs)H
Connection rodJ
Hydraulic cylinderK
Stop nutL
Continues on next page
Product manual - IRB 760 249
3HAC039838-001 Revision: M
© Copyright 2011-2018 ABB. All rights reserved.
4 Repair
4.4.6 Replacement of linkage - link
Continued