Refitting, parallel arm
Use this procedure to refit the parallel arm.
NoteAction
Refitting of the parallel arm is best performed on a
workbench.
1
Specified in Required equipment
on page 271
Apply some grease on the spacing sleeves on the
surfaces that face the parallel arm.
2
xx1000001376
Refit a spacing sleeve on each shaft.3
Art. no. is specified in Required
equipment on page 271
xx1000001377
Refit a bearing on each shaft with pressing tool,
lower arm.
4
Continues on next page
Product manual - IRB 760 275
3HAC039838-001 Revision: M
© Copyright 2011-2018 ABB. All rights reserved.
4 Repair
4.4.9 Replacement of parallel arm
Continued
To Next Page
Loading...
