NoteAction
xx1000001379
Lift the parallel arm, lower it and put it in mounting
position with the lower arm.
11
Art. no. is specified in Required
equipment on page 271.
Carefully press the parallel arm onto the lower arm
using the pressing tool, lower arm.
12
Fit the big and small VK cover.13
Detailed in section Replacing the
complete lower arm on page 261.
Refit the complete lower arm.14
Pendulum Calibration is described
in Operating manual - Calibration
Pendulum, enclosed with the cal-
ibration tools.
Recalibrate the robot.15
Axis Calibration is described in
Calibrating with Axis Calibration
method on page 360.
General calibration information is
included in section Calibration on
page 349.
DANGER
Make sure all safety requirements are met when
performing the first test run. These are further de-
tailed in the section First test run may cause injury
or damage on page 26.
16
Product manual - IRB 760 277
3HAC039838-001 Revision: M
© Copyright 2011-2018 ABB. All rights reserved.
4 Repair
4.4.9 Replacement of parallel arm
Continued
To Next Page
Loading...
