NoteAction
xx1000001271
Carefully refit the balancing device on the upper
and lower shafts.
8
Art. no. is specified in section Re-
quired equipment on page 278.
Fit the lubricating tool.
The tool should be tightened to the bottom po-
sition by hand power only.
9
Fill the bearings with grease through the nipple.10
Continue until grease excudes behind the inner
sealing.
Remove the lubricating tool and wipe off pro-
truding grease.
11
Specified in section Required equip-
ment on page 278.
Apply locking liquid on the threads of the lock
nuts.
12
Tightening torque: 120 Nm
xx1000001113
Refit the lock nuts and support washers.13
Check play (min. 0.1 mm) between support
washers and bearing seat at both bearings.
14
Remove the M12x50 screws from the balancing
device to restore the springforce.
15
Continues on next page
Product manual - IRB 760 285
3HAC039838-001 Revision: M
© Copyright 2011-2018 ABB. All rights reserved.
4 Repair
4.5.1 Replacing the balancing device
Continued
To Next Page
Loading...
