ABB IRB 760 Series - Page 286

NoteAction
xx1000001111
Refit the plastic screws in the M12 hole of the
balancing device.
16
xx1000001101
Remove the lock screw.17
DANGER
Make sure all safety requirements are met when
performing the first test run. These are further
detailed in the section First test run may cause
injury or damage on page 26.
18
286 Product manual - IRB 760
3HAC039838-001 Revision: M
© Copyright 2011-2018 ABB. All rights reserved.
4 Repair
4.5.1 Replacing the balancing device
Continued