InformationAction
Disconnect the brake release voltage.11
Remove the motor by gently lifting it straight
up and place it on a secure surface.
12
Refitting, motor axis 6
Use this procedure to refit motor axis 6.
InformationAction
xx1000001109
Make sure the o-ring on the circumference of
the motor is seated properly. Lightly lubricate
the o-ring with grease.
Note
The o-ring must be replaced when the motor is
replaced.
1
Parts:
• A: Pinion
• B: O-ring
• C: Circumference
Connect to connector R2.MP6
• + : pin 2
• -: pin 5
In order to release the brake, connect the 24
VDC power supply.
2
Art. no. is specified in Required
equipment on page 309.
Fit the two guide pins in two of the motor attach-
ment holes.
3
xx1000001108
Lift the motor carefully in place.
Make sure the motor pinion is properly mated
to the gearbox, axis 6.
Note
Make sure the motor is turned the correct way.
See figure!
4
Continues on next page
Product manual - IRB 760 313
3HAC039838-001 Revision: M
© Copyright 2011-2018 ABB. All rights reserved.
4 Repair
4.6.3 Replacing motor, axis 6
Continued
To Next Page
Loading...
