ABB PST Series - 8:1.2 AS-I

100 1SFC132003M0201
)LHOGEXVFRPPXQLFDWLRQRSWLRQ
&KDSWHU
 $6,
The AS-I protocol is a simple fieldbus protocol with a few
digital inputs and outputs. Through the outputs, the motor
can be started / stopped and an additional action can be
performed depending on the selected function on the
programmable input In0. The inputs correspond to the
programmable softstarter outputs (K4 - K6 and V7) where
status information can be acquired according to the set
function.
See Chapter 7 “Settings and configuration” for
programming the inputs / outputs.
Before the AS-I fieldbus can be put into operation, the
following parameters must be set in the softstarter:
• Parameter )LHOGEXV&WUOset to Yes
• Parameter )LHOGEXV7\SH set to AS-I
:DUQLQJ
,IWKHPRWRULVUXQQLQJDQGWKHSDUDPHWHU)LHOGE&WUOLV
FKDQJHGIURP1RWR<HVWKLVZLOOVWRSWKHPRWRUILHOGEXV
FRQWURORYHUULGHVWKHSURJUDPPDEOHLQSXWV
,IWKHPRWRULVQRWUXQQLQJDQGWKHSDUDPHWHU)LHOGE
&WUOLVFKDQJHGIURP<HVWR1RWKLVPLJKWVWDUWWKHPRWRU
LIWKHUHLVDVWDUWVLJQDOSUHVHQWRQWKHSURJUDPPDEOH
LQSXWV
For installation and commissioning of the AS-I fieldbus,
see document 2CDC191002D0202 available at
www.abb.com/lowvoltage
,I,QLVSURJUDPPHGDVHQDEOHLWPXVWDOZD\VEHVHW
WRJHWKHUZLWKDVWDUWFRPPDQG