ABB PST Series - 8:1.3 DeviceNet

102 1SFC132003M0201
)LHOGEXVFRPPXQLFDWLRQRSWLRQ
&KDSWHU
 'HYLFH1HW
The DeviceNet protocol is a fieldbus protocol that provides
full control and status information on the softstarter as well
as reading and writing of parameters. Through the fieldbus
it is possible to start and stop the motor, perform jog,
sequence start, read out currents and frequency, acquire
information about protections, warnings, faults and much
more.
See chapter 7 “Settings and configuration” for
programming the inputs / outputs.
Before the DeviceNet fieldbus can be put into operation,
the following parameters must be set in the softstarter:
• Parameter )LHOGEXV&WUO set to Yes
• Parameter )LHOGEXV7\SHset to other
• Parameter )LHOGEXV$GGU set to a free communication
address.
:DUQLQJ
,IWKHPRWRULVUXQQLQJDQGWKHSDUDPHWHU)LHOGE&WUOLV
FKDQJHGIURP1RWR<HVWKLVZLOOVWRSWKHPRWRUILHOGEXV
FRQWURORYHUULGHVWKHSURJUDPPDEOHLQSXWV
,IWKHPRWRULVQRWUXQQLQJDQGWKHSDUDPHWHU)LHOGE
&WUOLVFKDQJHGIURP<HVWR1RWKLVPLJKWVWDUWWKHPRWRU
LIWKHUHLVDVWDUWVLJQDOSUHVHQWRQWKHSURJUDPPDEOH
LQSXWV
For installation and commissioning of the DeviceNet
fieldbus, see document 2CDC193002D0201 available at
www.abb.com/lowvoltage.
)RUWKHVHWXSRIWKH3/&VSHFLILFVRIWZDUHLVUHTXLUHG
ZKLFKLVDYDLODEOHRQWKH6RIWVWDUWHUSDJHV
/RRNXQGHUWKHGRFXPHQWDWLRQOLQNQDPHG6RIWZDUH
,I\RXQHHGKHOSRUDGYLFHSOHDVHFRQWDFW\RXUORFDO$%%
RIILFH