ABB PST Series - 8:1.3.4 Binary output telegram

106 1SFC132003M0201
)LHOGEXVFRPPXQLFDWLRQRSWLRQ
&KDSWHU
 %LQDU\RXWSXWWHOHJUDP
From PLC to Softstarter.
:RUGLQ
RXWSXWGDWD
DUHD
%LQDU\
RXWSXWE\WH
%LW 'DWD 'HVFULSWLRQ
0 0 0 Start (1
st
par set if
Seq.start)
Commence a start when signal is
set. Start1 if sequence start.
1 Stop Commence a stop when signal is
negated.
2 Reset Events Reset signal for possible events.
3 Enable Enable, this bit must be set for run-
ning the motor.
4 Jog Perform Jog when signal is set.
5 DOL start Perform DOL start when signal is
set.
6Start2 (2
nd
par set
Seq.start)
Start2 if sequence start.
7Start3 (3
rd
par set
Seq.start)
Start3 if sequence start.
1 8 (0) Time synchronisation Time synchronisation signal that is
used to synchronise the local real
time clock with the time given as an
analog input telegram to the soft-
starter. If the signal is “1” and there is
a difference between the times, the
local real time clock is synchronised.
9 (1) Reset active diagnostics When set to “1” this will reset the
fieldbus diagnostic area.
10 (2) Spare
11 (3) Spare
12 (4) Spare
13 (5) Spare
14 (6) Spare
15 (7) Spare