ABB PST Series - 6:2.5 Event Log menu; 6:2.6 Status Information menu; 6:2.7 Reset Events menu

60 1SFC132003M0201
+XPDQ0DFKLQH,QWHUIDFH+0,
&KDSWHU
 (YHQW/RJPHQX
The Event Log menu is used to check the event log in the
softstarter. When entering this menu the twenty latest
events in the log are presented, in chronological order with
the latest event as No. 1, the second latest as No. 2 etc.
The events are presented with “type of event”, date and
time.
Use navigation keys to view all entries in the event log.
 6WDWXV,QIRUPDWLRQPHQX
The Status information menu is used to present various
information.
The information is presented one by one on the top row.
Use navigation keys to present all information.
 5HVHW(YHQWVPHQX
The Reset Events menu is entered automatically when a
fault has occurred or a protection is activated. It can also
be entered via the main menu.
Use navigation keys to view if there are several events to
reset.
Top level
)LJXUH (YHQW/RJPHQX
Settings
Event Log
Status Information
Reset Events
Local Control
Top level
Local Control
Settings
Event Log
Status Information
)LJXUH 6WDWXVLQIRUPDWLRQPHQX
Reset Events
'LVSOD\WH[W )XQFWLRQ
Connection Type of connection, In Line/
Inside Delta.
Frequency Measured frequency.
Phase L1 Phase current L1.
Phase L2 Phase current L2.
Phase L3 Phase current L3.
Run Time Total run time of the motor.
No. Of Starts Counted number of starts.
SW Ver. CU Software version CU.
SW Ver. FU Software version FU.
LV Board No Serial No of the LV PCB.
MAC Address Internal addressing.
Phase seq. Phase sequence indication.
Top level
Local Control
Settings
Event Log
Status Information
)LJXUH 5HVHW(YHQWVPHQX
Reset Events