ABB PST Series User Manual

71
1SFC132003M0201
6HWWLQJVDQGFRQILJXUDWLRQ
&KDSWHU
 %DVLF6HWWLQJV
The Basic settings menu consists of the most common
start/stop parameters required for the set-up. Each
parameter can be adjusted separately. For a deep
description of each parameter, see
Chapter 10 “Functions” .
(QWHUWKH%DVLFVHWWLQJV
Enter the menu by selecting %DVLF6HWWLQJV.
6HWWLQJ,
H
Set the current that the softstarter will be exposed to i.e.
rated motor current, if the unit is connected In Line.
)RUXQLWVFRQQHFWHG,QVLGH'HOWDWKH6HWWLQJ,
H
PXVWEHVHW
DFFRUGLQJWRWKHFXUUHQWLQWKHGHOWDFLUFXLW 
  RIWKHUDWHGPRWRUFXUUHQW
3UHVV6WRUHWRVDYHWKHGDWDDIWHUVHWWLQJWKHFXUUHQW
([WHUQDO%\3DVVFRQWDFWRU([W%\3DVV
Set the parameter to <HV if an External By-pass Contactor
is used, or else 1R.
6WDUWUDPS
Set the ramp time for start.
6WRSUDPS
Set the ramp time for stop (softstop). Note that this
function shall only be used for applications with small
flywheel masses, for example pumps and conveyors (in
case fragile material is transported).
,QLWLDOYROWDJH,QLW9ROW
Set the initial voltage level.
(QGYROWDJH(QG9ROW
Set the end voltage level.
T
op level
Settings
Application
Settings
Basic
Settings
Functional
Settings
Service
Settings
Presentation
Settings
All
Settings
Changed
Settings
Reset all
Settings
)LJXUH %DVLF6HWWLQJVPHQX
13e

ABB PST Series Specifications

General

Brand	ABB
Model	PST Series
Category	Controller
Language	English