ABB PST Series - 8:1.3.6 Input address map

107
1SFC132003M0201
)LHOGEXVFRPPXQLFDWLRQRSWLRQ
&KDSWHU
 $QDORJRXWSXWWHOHJUDP
From PLC to Softstarter.
All analog data will be represented as 16 bit values.
The output data is used to syncronise the softstarter real
time clock with a possible system clock.
It is used together with the binary output time
synchronisation signal. If this signal is set to "1" and there
is a difference between the clocks, the local softstarter
clock will be synchronised with the analog outputs.
 ,QSXWDGGUHVVPDS
:RUGLQRXWSXW
GDWDDUHD
$QDORJRXWSXW
ZRUG
'DWD 5HSUHVHQWDWLRQ
1 0 Year Value = 2003  Year 2003
2 1 Month Value = 12  December
3 2 Day Value = 31  31
st
4 3 Hour Value = 23  23 h
5 4 Minutes Value = 59  59 min
6 5 Seconds Value = 59  59 sec

0 Binary In, Byte 1 Binary In, Byte 0
1 Binary In, Byte 3 Binary In, Byte 2
2 Binary In, Byte 5 Binary In, Byte 4
3 Analog In, Word 0
4 Analog In, Word 1
5 Analog In, Word 2
6 Analog In, Word 3
7 Analog In, Word 4
8 Analog In, Word 5
9 Analog In, Word 6
10 Analog In, Word 7
11 Analog In, Word 8
12 Diagn. Channel 1, Error Code Diagn. Channel 1, Parameter No
13 Diagn. Channel 2, Error Code Diagn. Channel 2, Parameter No
14 Diagn. Channel 3, Error Code Diagn. Channel 3, Parameter No