ABB PST Series - 10:36 By-Pass fault, type of operation

137
1SFC132003M0201
)XQFWLRQV
&KDSWHU
 %\3DVVIDXOWW\SHRIRSHUDWLRQ
3DWKLQPHQX
0HQX6(77,1*6)XQFWLRQDO6HWWLQJV
)DXOWV%3)DXOW2S
This parameter makes it possible to select between three
different actions of the softstarter when the protection is
activated. It is active only if the by-pass monitor protection
is selected.
 +LJKFXUUHQWZDUQLQJ
3DWKLQPHQX
0HQX6(77,1*6)XQFWLRQDO6HWWLQJV
:DUQLQJV:DUQ, +LJK
If the function is selected, a warning signal will be given
provided that the current during full voltage is higher than
the set value. The measurement starts 30 seconds after
IXOOYROWDJH is reached.
Stop–M The motor stops and a manual reset is
required before restart.
Stop–A The motor stops and an automatic reset is
performed when the fault disappears
3DUDPHWHU
WH[W
'HIDXOWYDOXH 6HWWLQJUDQJH 'HVFULSWLRQ
BP Fault
Op
Stop–M Stop–M, Stop–A Type of opera-
tion for Bypass
fault
3DUDPHWHU
WH[W
'HIDXOWYDOXH 6HWWLQJUDQJH 'HVFULSWLRQ
Warn
I=High
No Yes, No High current
warning