ABB PST Series - 6:2.4.1 Start;Stop the motor

59
1SFC132003M0201
+XPDQ0DFKLQH,QWHUIDFH+0,
&KDSWHU
 6WDUW6WRSWKHPRWRU
6WDUW
Enter the Start/Stop menu, figure 22.
Select6WDUWThe motor will now start and run according to
the set parameters.
6WRS
Select 6WRS. The motor will stop according to the set
parameters. It is possible to press stop command during
the start ramp if required.
 -RJ
Enter the Jog menu, figure 23.
Select -RJ The motor will start and accelerate to rated
speed according to the set parameters as long as the Jog
command is activated.
The motor stops immediately as soon as the command is
released.
 '2/VWDUW
367%RQO\
6WDUWIURPWKHVRIWVWDUWHU
If required, the motor can be started DOL (Direct On Line)
with the integrated by-pass contactor.
Select the DOL start menu, figure 25.
Select '2/VWDUW to close the integrated by-pass contactor.
Select 6WRS to open the contactor.
:DUQLQJ
7KHUDWHGPRWRUFXUUHQWPXVWQHYHUH[FHHGWKH'2/
UDWLQJRIWKHLQWHJUDWHGE\SDVVFRQWDFWRU
)LJXUH 6WDUW6WRSPHQX
Top level
Local Control
Settings
Start/Sto
p
Jog
DOL St
art
Event Log
Status Information
Reset Events
Top level
Local Control
)
LJXUH -RJPHQX
Jog
Settings
Event Log
Status Information
Reset Events
Start/Sto
p
DOL Sta
rt
Top level
Local Control
)LJXUH '2/VWDUWPHQX
DOL start
Settings
Event Log
Status Information
Reset Events
Jog
Start/Stop