ABB PST Series - 8:1.3.3 Diagnostic inputs

105
1SFC132003M0201
)LHOGEXVFRPPXQLFDWLRQRSWLRQ
&KDSWHU
 'LDJQRVWLFLQSXWV
There are 3 channels available for fieldbus related
diagnostic messages. Each channel consists of two bytes
with an error code and the parameter number that caused
the error. The latest error is stored in channel 1, the
second latest in channel 2 and the third latest in channel
3. The binary output bit "reset active diagnostics" is used
to clear the diagnostic area.
Error Codes:
1 = Parameter Value out of range.
2 = Invalid parameter number.
3 = Write of parameter when fieldbus control is not
enabled.
:RUGLQLQSXWGDWD
DUHD
'LDJQRVWLFLQSXW
ZRUG
(UURU&RGH 3DUDPHWHUQXPEHU
12 0 Diagn. Channel 1, Error Code Diagn. Channel 1,
Parameter No
13 1 Diagn. Channel 2, Error Code Diagn. Channel 2,
Parameter No
14 2 Diagn. Channel 3, Error Code Diagn. Channel 3,
Parameter No