ABB PST Series - 6:2.4 Local Control menu

58 1SFC132003M0201
+XPDQ0DFKLQH,QWHUIDFH+0,
&KDSWHU
 /RFDO&RQWUROPHQX
The Local Control menu is used to start or stop the motor
from the keypad. When a type of local control is selected
the softstarter can only be controlled by the keypad.
The softstarter operation state (stopped/running) remains
when selecting control until it is changed there. Previous
type of control is activated again when the type of control
is exited.
Three different selections are possible (see the table
below).
Press navigation keys to view different types of control.
7KH/2&$/&21752/PHQXFDQQRWEHHQWHUHGLI
6HTXHQFHVWDUWLVVHOHFWHG
Once the motor has been started in this menu, it must first
be stopped before you leave the menu. If the motor is
already running when the menu is entered it is possible to
leave immediately without stopping the motor.
Top level
Local Control
)LJXUH /RFDOFRQWUROPHQX
Settings
Event Log
Status Information
Reset Events
Start/Sto
p
Jog
DOL Sta
rt
)XQFWLRQ 'HVFULSWLRQ
Start/stop To start and stop the motor
with the keypad.
Jog To run the motor as long as
Jog is pressed.
DOL start
(PSTB370...PSTB1050
only)
To start and stop the motor
with the built-in by-pass con-
tactor.