ABB PST Series - Chapter 4 Mounting; 4:1 Receiving, unpacking and checking; 4:1.1 Intermediate storage; 4:2 Mounting

33
1SFC132003M0201
0RXQWLQJ
&KDSWHU
&KDSWHU0RXQWLQJ
This chapter describes instructions on how to receive the
softstarter and how to mount it in a proper way.
 5HFHLYLQJXQSDFNLQJDQG
FKHFNLQJ
• Check that the package is turned with the correct side
up, figure 1.
• Remove the transport casing.
• Visually inspect the softstarter.
Check that the serial number corresponds with the
delivery documents.
• Check that all items are included, according to the
delivery note.
• Check for transport damages.
Check the softstarter as well as the package. If you find
any damages, please contact the transport company or
the supplier immediately.
 ,QWHUPHGLDWHVWRUDJH
Until the softstarter is mounted it should be stored in its
package.
 0RXQWLQJ
 +DQGOLQJZKHQPRXQWLQJ
The softstarter is available in five physical sizes. The
models PST30 to PST300 can be taken out of the
packages and be mounted without lifting equipment.
For mounting of models PST370 to PSTB1050, lifting
equipment is recommended due to the weight.
See Chapter 3 “Description”, for weights.
:DUQLQJ
'RQRWOLIWWKHVRIWVWDUWHULQWKHFRQQHFWLRQEDUVVLQFHLW
PD\FDXVHGDPDJHWRWKHSURGXFW
)LJXUH 3DFNDJH