EasyManua.ls Logo

ABB PST Series - Page 110

ABB PST Series
178 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
110 1SFC132003M0201
)LHOGEXVFRPPXQLFDWLRQRSWLRQ
&KDSWHU
34 Read/Write PTC Op Type of operation for PTC protection Stop–M, Stop–A, Ind
35 Read/Write Ext ByPass External By-pass contactor is used No, Yes
36 Read/Write BP Fault Op Type of operation for by-pass moni-
tor protection
Stop–M, Stop–A
37 Read/Write Warn I=High High current warning No, Yes
38 Read/Write Wa I=H Lev Trip level for high current warning 0,5 – 5,0 x Ie
39 Read/Write Warn I=Low Low current warning No, Yes
40 Read/Write Wa I=L Lev Trip level for low current warning 0,4 – 1,0 x Ie
41 Read/Write Warn OL Overload warning No, Yes
42 Read/Write Wa OL Lev Trip level for overload warning 40 – 99 %
43 Read/Write Warn SCR OL Thyristor overload warning No, Yes
44 Read/Write Ph Loss Op Type of operation for phase loss
fault
Stop–M, Stop–A
45 Read/Write FB Fault Op Type of operation for fieldbus fault Stop–M, Stop–A
46 Read/Write Freq F Op. Type of operation for frequency fault Stop–M, Stop–A
47 Read/Write HS Temp Op Type of operation for heat sink over
temperature fault
Stop–M, Stop–A
48 Read/Write SCR SC Op Type of operation for thyristor short
circuit fault
Stop–M, Stop–A
49 Read In0 Function of programmable input In0 None, Reset, Enable,
Jog, DOL-on, Start2
50 Read In1 Function of programmable input In1 None, Reset, Enable,
Jog, DOL-on, Start3
51 Read/Write Relay K4 Function of programmable relay out-
put K4
Run, TOR, Event
52 Read/Write Relay K5 Function of programmable relay out-
put K5
Run, TOR, Event
53 Read/Write Relay K6 Function of programmable relay out-
put K6
Run, TOR, Event
54 Read/Write SW Outp V7 Function of programmable software
output V7
Run, TOR, Event
55 Read/Write Event K4 Different events to include for signal-
ling with K4 if “Event” is selected
0 – 65535, Bit mask
see separate
description.
56 Read/Write Event K5 Different events to include for signal-
ling with K5 if “Event” is selected
0 – 65535, Bit mask
see separate
description.
57 Read/Write Event K6 Different events to include for signal-
ling with K6 if “Event” is selected
0 – 65535, Bit mask
see separate
description.
58 Read/Write Event V7 Different events to include for signal-
ling with V7 if “Event” is selected
0 – 65535, Bit mask
see separate
description.
59 Read Fieldb Ctrl Control of the softstarter with field-
bus
No, Yes
60 Read Fieldb Type Type of fieldbus AS-I, Other
61 Read Fieldb Addr Fieldbus address 0 – 1000
1R 7\SH 3DUDPHWHU 'HVFULSWLRQ 5DQJH 8QLW

Table of Contents

Related product manuals