ABB PST Series - Page 69

69
1SFC132003M0201
6HWWLQJVDQGFRQILJXUDWLRQ
&KDSWHU
6HWWLQJ,
H
Set the current that the softstarter will be exposed to i.e.
rated motor current if the unit is connected In Line.
)RUXQLWVFRQQHFWHG,QVLGH'HOWDWKH6HWWLQJ,
H
PXVWEHVHW
DFFRUGLQJWRWKHFXUUHQWLQWKHGHOWDFLUFXLW 
  RIWKHUDWHGPRWRUFXUUHQW
3UHVV6WRUHWRVDYHWKHGDWDDIWHUVHWWLQJWKHFXUUHQW
Confirm the 6HWWLQJ,
H
by pressing 1H[W. If wrong Setting I
e
was set, press %DFN and set the correct value.
2YHUORDGFODVV2/&ODVV
Select the class for the overload relay for the used
application type. Available classes:
•10
• 10A
•20
• 30
Press 6WRUH to save the selected class.
Confirm the selected overload class by pressing1H[W. If
wrong overload class was selected, press %DFN and select
the correct class.
([WHUQDO%\3DVVFRQWDFWRU([W%\3DVV
If an External By-Pass contactor is used, set the
parameter to <HV, otherwise 1R.
Press 6WRUH to save the data.
Confirm the selection of external by-pass by pressing
1H[W. If wrong selection was made, press %DFN and
correct the selection.
7XQH6HW
The configuration of the application setting menu is now
completed. If no tuning of the settings is wanted, it is
possible to return to the top level by pressing <HV.
If tuning of some main parameters is wanted, select 7XQH
6HW.
5GVVKPI+G #
5VQTG
)LJXUH 6HWWLQJ,HPHQX
5GVVKPI+G #
0GZV $CEM
)LJXUH &RQILUPLQJ6HWWLQJ,H
1.%NCUU 
5VQTG
)
LJXUH2YHUORDGFODVV
1.%NCUU 
0GZV $CEM
)LJXUH &RQILUPLQJ2/&ODVV
'ZV$[2CUU ;GU
5VQTG
)LJXUH &RQILUPLQJ2/&ODVV
'ZV$[2CUU ;GU
0GZV $CEM
)LJXUH &RQILUPLQJ2/&ODVV
4GCF[!
;GU 6WPG5GV
)LJXUH 5HDG\"7XQH6HWPHQX
13e