Page 146
© Copyright 2021 ABB. All rights reserved.
Syntax: bye
Description
This command is used to terminate the session.
Syntax: cha obj,attr=value
where: obj,attr is an object-attribute pair. For example, ps1,sid.
Description
This command is used to change system configuration parameters. Examples are listed below to
illustrate how this command works.
cha ps1,sid="My Plant"Change the site id to My Plant
cha p1,phn="123456789"Change the primary phone number to 123456789
You must be logged in as a super-user or administrator to use this command. “” are required for all IP
addresses and associated descriptions.
Syntax: cle
Description
This command is used to clear latched events. These events include communication failures, missing
rectifiers, missing thermal probes, missing voltage monitoring module, distribution fuses, and loss of
redundancy alarm.
You must be logged in as a super-user to use this command.
Syntax: his
Description
Syntaxhis
where: obj,attr is an object-attribute pair as defined in the following: sum dc1,adc- report plant load
current statistics
sum br1,hbt- report highest battery temperature statistics
Syntax: his bs1,stt
Description
This command reports the boost history in the following format: sum bs1,stt
30-MAY-03,15:11:12,RESUMED,COMPLETED,78
30-MAY-03,12:03:34,AUTO,DISCHARGE,14
bye Log - off
Cha Change Value
Cle Clear All Latched Events
his Report Alarm History
his Report Boost History
To Next Page
Loading...
Need help?
General
