Function IEC 61850 A B C
CE01 CE02 CE03
Sequence current measurement CSMSQI 1 1 1
Residual current measurement RESCMMXU 1 1 1
Three-phase voltage measurement VMMXU 1
1 (2)
13)
1
Sequence voltage measurement VSMSQI 1
1 (2)
13)
1
Three-phase power and energy measurement PEMMXU 1 1 1
Frequency measurement FMMXU 1 1 1
Load profile LDPMSTA 1 1 1
Other
Minimum pulse timer (2 pcs) TPGAPC 2 2 2
Minimum pulse timer (2 pcs, second resolution) TPSGAPC 1 1 1
Minimum pulse timer (2 pcs, minute resolution) TPMGAPC 1 1 1
Pulse timer (8 pcs) PTGAPC 2 2 2
Time delay off (8 pcs) TOFGAPC 2 2 2
Time delay on (8 pcs) TONGAPC 2 2 2
Set reset (8 pcs) SRGAPC 2 2 2
Move (8 pcs) MVGAPC 8 8 8
Generic control point (16 pcs) SPCGGIO 2 2 2
Remote generic control points SPCRGGIO 1 1 1
Local generic control points SPCLGGIO 1 1 1
Generic up-down counters UDFCNT 3 3 3
Analog value scaling function SCA4GAPC 12 12 12
Integer value moving function MVI4GAPC 2 2 2
1, 2, ... = number of included instances
() = optional
1) All directional protection functions can also be used in the non-directional mode
2) The instances of a protection function represent the number of identical protection function blocks available in the standard configuration
3) Only one can be ordered as an option at a time with OC or directional OC
4) Can be ordered as an option when OC is also chosen
5) Io selectable by parameter, Io measured by default
6) Can be ordered as an option when OC or directional OC is also chosen
7) One of the three can be ordered as an option when directional OC and directional EF are chosen: Admittance based EF, Wattmetric
based EF or Harmonics based EF
8) Uo calculated is always used
9) Uo calculated is always used with the first instance
10) UoB calculated is always used with the second instance
11) Voltage group B is always used with the third instance
12) Must be added with Application Configuration to be available in Signal Matrix and in the relay
13) Voltage group B is always used with the second instance
1MRS757807 B Section 2
DNP3 data mappings
Remote Monitoring and Control REC615 17
Point List Manual
To Next Page
Loading...
