600T & 600T EN PRESSURE TRANSMITTER
CREATE/MODIFY CONFIGURATION
Q - 14
Key Display Comments
Select NEW to create a configuration. To modify an
existing configuration, select MODIFY. The screen
sequence is the same, however, the MODIFY
screens will appear with the values and arrow posi-
tions as they were originally configured.
Select HART.
Select 600T.
Enter a name for the configuration ID tag using up to
eight ASCII characters. To select a character, press
the key that has the desired character. Continue to
press the key until the desired character appears.
Use the right arrow key to move to the next charac-
ter. Use the left arrow key to go back to the previous
character.
Select ANALOG.
NOTE: The DIGITAL selection should only be made
when using an IMFBS01 field bus I/O module. A
CHANNEL # prompt appears when DIGITAL is
selected.
Type a descriptive message using up to 32 charac-
ters. This field can be used to note anything of impor-
tance to the device or installation.
To select a character, press the key that has the
desired character. Continue to press the key until the
desired character appears. Use the right arrow key to
move to the next character. Use the left arrow key to
go back to the previous character.
CONFIG
ENTER
CONFIGURATION
→ NEW
MODIFY
ERASE
ENTER
DEVICE TYPE
ABB FSK
→ HART
[ 6 TIMES ]
ENTER
TRANSMITTER TYPE
PTH EBTH
TB82 pH TB82 ORP
TB82 pION TB82 CONC
TZID/AXH AS800
TEU211 TS11/TS01
50XE4000 50XM2000
50SM‘1000 →600T
HART UNIV
ENTER
STT04 CONFIGURATION
[]
←PREVIOUS NEXT→
ENTER
SELECT MODE:
→ ANALOG
DIGITAL
ENTER
MESSAGE:
←PREVIOUS NEXT→
To Next Page
Loading...
