ABB STT04 - Page 272

Worksheet
STT04
EQS Platinum Standard Series Smart Temperature
Transmitter Configuration
IDTAG (≤14 digits, alphanumeric)
MODE □ Analog □ Digital ____ Channel Number
TRANSMITTER MODE □ Thermocouple □ RTD □ Millivolt □ Ohms
Thermocouple □ N □ B □ E □ J □ K □ R □ S □ T □ C
RTD □ 100 Ohms (pt 385) □ 100 Ohms (pt 392)
NUMBER OF ELEMENTS □ Single □ Dual
Number of Wires □ 2 □ 3 □ 4
ENGINEERING UNITS □ Celsius □ Fahrenheit □ Kelvin
OUTPUT TYPE
Function Generator □ Yes □ No
Input _______%
_______%
_______%
_______%
_______%
Point 1
Point 2
Point 3
Point 4
Point 5
Output _______%
_______%
_______%
_______%
_______%
Point 1
Point 2
Point 3
Point 4
Point 5
OUTPUT ACTION □ Normal □ Reverse
DAMPING _______ sec (0.00 to 32.00 sec)
LOWER RANGE VALUE _______ Specified LRV _______ LRV
UPPER RANGE VALUE _______ Specified URV _______ URV
INITIALIZE MODE
2
□ Low □ High
FAIL MODE
2
□ Low □ High □ Last
SECONDARY UNITS _______ Secondary LRV _______ Secondary URV
TEMPERATURE ALARM _______ Lower _______ Upper
NOTES:
1. Default parameters.
2. Select to maintain safe operation during start-up and diagnostically detected failures of the transmitter.