ABB STT04 - Page 271

Worksheet
STT04
EQN Smart Electronic Temperature Transmitter
Configuration
IDTAG (≤14 digits, alphanumeric)
MODE □ Analog □ Digital ____ Channel Number
SENSOR TYPE
□ Thermocouple □ N □ B □ E □ J □ K □ R □ S □ T □ C
□ RTD □ 100 Ohms (Pt 385) □ 100 Ohms (Pt 392)
Type □ 2-wire □ 3-wire □ Dual
□ MILLIVOLT
□ OHMS □ 2-wire □ 3-wire □ Dual
OUTPUT TYPE
Function Generator □ Yes □ No
Input _______%
_______%
_______%
_______%
_______%
Point 1
Point 2
Point 3
Point 4
Point 5
Output _______%
_______%
_______%
_______%
_______%
Point 1
Point 2
Point 3
Point 4
Point 5
OUTPUT ACTION □ Normal
1
□ Reverse
DAMPING _______ sec (0.00
1
to 32.00 sec)
ENGINEERING UNITS
2
□ Celsius □ Fahrenheit □ Kelvin
LOWER RANGE VALUE _______ Specified LRV _______ LRV
UPPER RANGE VALUE _______ Specified URV _______ URV
INITIALIZE MODE
3
□ Low □ High
FAIL MODE
3
□ Low □ High □ Last
NOTES:
1. Default parameters.
2. Not applicable in millivolt mode.
3. Select to maintain safe operation during start-up and diagnostically detected failures of the transmitter.