ABB STT04 - Page 274

Worksheet
STT04
PTS Smart Electronic Pressure Transmitter Configuration
IDTAG (≤14 digits, alphanumeric)
MODE □ Analog □ Digital ____ Channel number
OUTPUT TYPE □ Linear
1
□ Vol./sphere
□ Square root
□ Vol./cylinder
□ 3/2 flow mode
□ Function generator
□ 5/2 flow mode
FUNCTION GENERATOR
Input _______%
_______%
_______%
_______%
_______%
_______%
Point 0
Point 1
Point 2
Point 3
Point 4
Point 5
Output _______%
_______%
_______%
_______%
_______%
_______%
Point 0
Point 1
Point 2
Point 3
Point 4
Point 5
OUTPUT ACTION □ Normal
1
□ Reverse
DAMPING _______ sec (0.00
1
to 32.00 sec)
ENGINEERING UNITS □ iH
2
O
1
□ mmHg □ cmH
2
O □ psi □ MPA
□ kPa □ BARS □ mBARS □ kg/cm
2
LOWER RANGE VALUE _______ Specified LRV
UPPER RANGE VALUE _______ Specified URV
INITIALIZE MODE
2
□ Low □ High
FAIL MODE
2
□ Low □ High □ Last
SECONDARY UNITS _______ Secondary LRV _______ Secondary URV
TEMPERATURE ALARM _______ Lower _______ Upper
NOTES:
1. Default parameters.
2. Select to maintain safe operation during start-up and diagnostically detected failures of the transmitter.