ABB STT04 - Page 275

Worksheet
STT04
TBN480 Smart Conductivity
Transmitter Configuration
IDTAG (≤14 digits, alphanumeric)
MODE □ Analog □ Digital ____ Channel Number
ANALYZER TYPE □ General □ Pure H
2
O Cond. □ Concentration
SENSOR GROUP □ A □ B □ C
RANGE JUMPER □ High □ Medium □ Low
ANALYZER RANGE □ 0-99.9
µ
S/cm □ 0-9.99
µ
S/cm
TEMP. COMP. INPUT □ Manual □ 3.01k Balco
DAMPING _______ sec (0.00
1
to 32.00 sec)
LOWER RANGE VALUE _______ Specified LRV _______ LRV
UPPER RANGE VALUE _______ Specified URV _______ URV
INITIALIZE MODE
2
□ Low □ High
FAIL MODE
2
□ Low □ High □ Last
DIAG. SPIKE OUTPUT □ No □ Yes
NOTES:
1. Default parameters.
2. Select to maintain safe operation during start-up and diagnostically detected failures of the transmitter.