ABB STT04 - Page 277

Worksheet
STT04
TBN581 Smart ORP/pION Transmitter Configuration
IDTAG (≤14 digits, alphanumeric)
MODE □ Analog □ Digital ____ Channel Number
OUTPUT TYPE
Function Generator □ Yes □ No
Input _______%
_______%
_______%
_______%
_______%
Point 1
Point 2
Point 3
Point 4
Point 5
Output _______%
_______%
_______%
_______%
_______%
Point 1
Point 2
Point 3
Point 4
Point 5
OUTPUT ACTION □ Normal
1
□ Reverse
DAMPING _______ sec (0.00
1
to 32.00 sec)
LOWER RANGE VALUE _______ Specified LRV _______ LRV
UPPER RANGE VALUE _______ Specified URV _______ URV
INITIALIZE MODE
2
□ Low □ High
FAIL MODE
2
□ Low □ High □ Last
SECONDARY UNITS _______ Secondary LRV
_______ Secondary URV
NOTES:
1. Default parameters.
2. Select to maintain safe operation during start-up and diagnostically detected failures of the transmitter.