ABB STT04 - Page 278

Worksheet
STT04
XM/SM/XE Magnetic Flowmeter Configuration
IDTAG (≤14 digits, alphanumeric)
MODE □ Analog □ Digital ____ Channel Number
FLOW DIRECTION □ Normal □ Reverse
DAMPING _______ sec (0.00
1
to 32.00 sec)
SELECT PV EU □ 1/s □ 1/m □ 1/h □ m3/s □ m3/m
□ m3/h □ gal/s □ gal/m □ gal/h □ User defined
RANGE DN _______ PV EU
EU DESCRIPTOR _____________________
EU FACTOR ______________
TIME RELATION □ Per sec □ Per min □ Per hour
DENSITY FACTOR _____________________
RANGE VALUE 1 _______ Units
RANGE VALUE 2 _______ Units
FAIL MODE
2
□ Low □ High
SELECT TOTALIZER EU □ 1 □ m3 □ gal □ User defined
PULSE FACTOR ______________
PULSE WIDTH ______________
LOW FLOW CUTOFF ______________ %
DIGITAL FILTER □ On □ Off
RESPONSE TIME □ Normal □ Fast
RANGE CONFIGURATION □ 2-fwd □ 1-fwd, 1-rev
FLOW DIRECTION □ Fwd and rev □ Fwd only
UPPER PV ALARM ______________ Units
EMPTY PIPE DET □ On □ Off
LOWER PV ALARM ______________ Units
NOTES:
1. Default parameters.
2. Select to maintain safe operation during start-up and diagnostically detected failures of the transmitter.