ABB Terra 124 - Safety Instructions During Transport; Safety Instructions for Earthing; Safety Instructions for Use

• Make sure that the load capacity of the grid is in accordance with the EVSE.
• Earth the EVSE correctly. Refer to section 2.8.
• Make sure that the wiring inside the EVSE is protected from damage and cannot
get trapped when you open or close the cabinet.
• Make sure that water cannot enter the cabinet.
• Protect the EVSE with safety devices and measures that the local rules specify.
• If it is necessary to remove safety devices, immediately install the safety devices
after the work.
• Put on the correct personal protective equipment. Refer to section 2.5.
2.7 Safety instructions during transport
Preliminary requirements
• Installation engineer
•
• Make sure that the hoisting equipment or forklift truck can lift the EVSE safely.
Take into account the mass and the center of gravity of the EVSE.
• Obey the safety instructions that apply to the hoisting equipment or the forklift
truck.
• Put on the correct personal protective equipment. Refer to section 2.5.
2.8 Safety instructions for earthing
Preliminary requirements
•
• Make sure that the EVSE is connected to a grounded, metal, permanent wiring
system, or an equipment-grounding conductor must be run with the circuit
conductors and connected to the equipment grounding terminal or lead on the
product.
• Make sure that the connections to the EVSE comply with all applicable local
rules.
2.9 Safety instructions for use
• In these situations, do not use the EVSE and immediately contact the
manufacturer:
• An enclosure has damage.
• An EV charge cable or connector has damage.
• Lightning struck the EVSE.
• There was an accident or a fire at or near the EVSE.
• Water has entered the EVSE.
Safety
16 9AKK108466A3703-EN | 001