7 Maintenance and cleaning
7.1 Maintenance schedule
Task Frequency Procedure
Clean the cabinet. 4 months Refer to section 7.2.
Do a check for damage on
the EV charge cables and
the connectors.
3 months Refer to section 7.3.
Do a check for damage on
the cabinet.
6 months Refer to section 7.3.
Replace the filters for the
air inlets.
1 year Refer to section 7.4.
Make sure that the manu-
facturer does maintenance
on the EVSE.
1 year Ask the manufacturer to
do the task. Refer to sec-
tion 1.12.
For the complete mainte-
nance schedule refer to
section 7.1.
For the required spare
parts refer to section
10.22.
Replace the filters for the
air outlets.
After the first year, then 2
years
Refer to section 7.5.
7.2 Clean the cabinet
Preliminary requirements
• Owner
• Cleaning agent and a non-
abrasive tool. Refer to
section 10.21.
Danger:
Hazardous voltage
• Do not apply high-pressure water jets. Water can leak into the
cabinet.
Note: When the EVSE is put in a corrosion sensitive environment,
superficial rust is possible on welding points. This rust is only visual.
There is no risk for the integrity of the cabinet. The procedure below
removes the rust.
Procedure
1. Rinse with low-pressure tap water to remove rough dirt.
2. Apply a solution of cleaning agent to the cabinet and let it soak.
Maintenance and cleaning
9AKK108466A3703-EN | 001 65
To Next Page
Loading...
