ABB Terra 124 - Do a visual check of the EVSE; Replace the air inlet filter

6.8.4 Install new software
1. On the hardware screen, select Trigger discovery .
The screen gives feedback if the trigger discovery has been started or failed.
The system tries to discover new hardware, installs software on the hardware
and assigns node IDs. During this discovery, the local service portal is closed.
The screen shows the message Out of order .
2. Do not turn off the EVSE during the discovery process.
3. Wait until the discovery process is finalized.
The discovery of new hardware can take up to 15 minutes. At the end of
the discovery process, the new software is installed. The system starts the
processes again in the background and the screen goes into idle mode.
6.8.5 Close the local service portal
1. On the touchscreen, select
Exit .
2. Select Confirm in the dialog box.
The HMI will switch to the user application. After 5 minutes of touch inactivity
on the screen, the local service portal will close. The HMI will switch to the
regular EVSE application.
3. If the local service does not close automatically, select the Trigger Discovery
button.
Operation
64 9AKK108466A3703-EN | 001