3. Manually remove dirt. Use the non-abrasive tool.
Caution: Do not use abrasive tools. There is a risk of damage to
the finish of the EVSE, that can cause deep corrosion and structural
damages.
4. Rinse with low-pressure tap water.
5. If necessary, apply wax on the front for extra protection and gloss.
6. If there was rust and you want it not to appear again, apply a rust-preventive
primer. Ask the manufacturer for specifications and instructions.
7.3 Do a visual check of the EVSE
Preliminary requirements
• Owner
Procedure
1. Do a visual check for damage on these parts:
Part
Damage
EV charge cables and connectors Cracks or ruptures
Internal wires of the cable are visible
Touchscreen Cracks
Touchscreen does not work
Coating of the cabinet Cracks or ruptures
Cabinet Signs of rust that cause ingress of wa-
ter
2. If you see damage, contact the manufacturer. Refer to section 1.12.
7.4 Replace the air inlet filter
Preliminary requirements
• Owner
• Air inlet filters. Refer to
section 10.22.
• Spanner
Maintenance and cleaning
66 9AKK108466A3703-EN | 001
To Next Page
Loading...
