ABB Terra 124 - Tilt Sensors Installation (Option); General Procedure; Install the Bracket of the Tilt Sensors

Procedure
1. Connect the Ethernet cable (A) to the
Ethernet RJ45 socket (B).
Note: Daisy chaining of
Ethernet between the
EVSEs or network points is
not supported.
5.7 Tilt sensors installation (option)
5.7.1 General procedure
For all specifications of the tilt sensors, refer to section 10.10.
1. Install the bracket (A). Refer to section
5.7.2.
2. Install the tilt sensors (B). Refer to
section 5.7.3.
3. Connect the tilt sensors. Refer to
section 5.7.4.
5.7.2 Install the bracket of the tilt sensors
Preliminary requirements
• Installation engineer
• Tilt sensor lugged
• Bracket
• Alternative bracket
• Screwdriver 3.5 mm
• Cross screwdriver size 2
B A
A
B
Installation
52 9AKK108466A3703-EN | 001