Machine Maintenance Procedures 3-37
Figure 3-36. Freeing Mainboard Connectors
Connectors on left side of mainboard (i.e. USB 3.0, HDMI, etc.) are set in lower cover
slots. Do not force mainboard when removing.
6. Remove mainboard from lower cover by pulling away from left side (A).
7. Flip mainboard over to show DC-IN connector on mainboard (Figure 3-37).
DC-IN cable is connected to the mainboard. Do not pull mainboard away from
lower cover.
Figure 3-37. Mainboard DC-IN Connector
8. Disconnect DC-IN cable (B) from mainboard connector (A).
9. Remove mainboard from lower cover.
SG_JE50_HR.book Page 37 Thursday, December 23, 2010 3:47 PM
To Next Page
Loading...
