6146/6156 DC Voltage/Current Generators Operation Manual
1.5.1 Environmental Conditions
1-5
Figure 1-1 Operating Environment
NOTE: Warm-up Time
Allow the 6146/6156 to warm up for at least 30 minutes after turning on the power to ensure the specified
accuracy of the 6146/6156.
• Keep the rear panel more than 10 centimeters
away from the wall.
• Do not position the 6146/6156 in a posi-
tion with the rear panel facing down.
• Avoid operation in these areas.
• Use a noise-cut filter when there is a large
amount of noise riding on the power line.
Line Filter
Corrosive
gas
Direct sunlight
Dust
Vibration
Front
Front
To Next Page
Loading...
Need help?
General
