CHAPTER 4
184
Editing Video
These methods are most useful when you want to remove frames from the middle of a clip
or across multiple clips on the same track. If you just want to remove frames from one end
of a clip, simply trim the end of the clip (see “Editing a clip that exists between other
Timeline clips” on page 176).
To remove frames without affecting other clips (lift):
Do one of the following:
• To remove an entire clip, select the clip in the Timeline and press the Delete key.
• To remove a range of frames, use the program controller to specify the In and Out points
to remove, and click the Lift button ( ) in the Monitor window.
To remove frames and close the resulting gap (extract):
Do one of the following:
• To remove an entire clip, select the clip in the Timeline and choose Edit > Ripple Delete.
• To remove a range of frames, use the program controller to specify the In and Out points
to remove, and click the Extract button ( ) in the Monitor window.
To delete all clips on one track:
Select the track select tool ( ), click the first clip in the track, and press Delete.
Note: You can also delete a track; see “Adding, naming, and deleting tracks” on page 144.
c00.book for PS Page 184 Tuesday, March 31, 1998 1:28 PM
To Next Page
Loading...