CHAPTER 11
332
Producing Final Video
• To process a continuous range of projects in the list, click to select the first project you want
to process, hold down Shift as you click the last project you want to process, click Make, select
Make Selected Sources Only, and click OK.
• To process a discontinuous range of projects in the list, click to select the first project you
want to process, hold down Control (Windows) or Command (Mac OS) as you click each
additional project you want to process, click Make, select Make Selected Projects Only, and
click OK.
Note: If you click Cancel, you will lose all of your changes since you opened the Batch Processing
dialog box. If you decide not to make a movie but want to retain batch list settings you specified,
save your settings as described in the following procedures. At a later time, you can open the Batch
Processing dialog box and load those settings.
To save, load, or delete an item from the Batch Processing list:
When the Batch Processing window is open, do any of the following:
• To delete a project or clip from the Batch Processing list, select a project or clip in the list,
and click Delete.
• To save the Batch Processing list to disk, click Save, specify a location and filename,
and click Save.
• To load a Batch Processing list from disk, click Load, locate and select a batch processing
list file, and click Open.
c11.fm Page 332 Wednesday, April 1, 1998 10:08 AM
To Next Page
Loading...