153
Appendix C
Regulatory Notices
• This product has been designed and manufactured in accordance with U.S., Canadian,
and European regulatory requirements as outlined below. Modifications made to this
product that are not expressly approved in writing by the manufacturer will void the
user’s authority to operate this product, previously issued factory approvals, and the
user’s rights under the warranty.
• The distributor or dealer may have applied additional local, national, or international
approvals to this product. Consult the distributor or dealer for more information and
documentation.
• Connections to this product must be made with shielded cables. Use of non-shielded
cables may violate RFI/EMI limits.
Symbol Conventions
This symbol indicates conformity to relevant European directives.
98214
This symbol indicates the product was tested to conform to relevant Canadian and U.S. safety
standards by Intertek Testing Services NA, Inc. The ETL mark is approved in the United States
as a Nationally Recognized Testing Lab (NRTL) by OSHA, and in Canada by the Standards
Council of Canada.
In Vitro Diagnostic Medical Device complying with EU Directive 98/79/EC.
This symbol, depending upon its location, indicates the assembly, component, and/or
product are free of lead. In respect to its inclusion on a circuit component or assembly, the
following must be adhered to when servicing. Failure to do so may result in defects caused
by dissimilar metals.
1. Do not repair or modify using a lead-containing solder.
2. Do not repair or modify using any soldering tools that have been in contact with lead-
containing solders.
3. Do not repair or modify with any lead-free solder other than that specified by the
manufacturer or as indicated by the symbology of standard IPC-1066.
4. Do not repair or modify using any soldering tools that have been in contact with any other
incompatible lead-free solders.
5. Contact factory service for further information.
The number in this symbol indicates the type of lead-free solder used in the assembly of
printed circuit boards, per standard IPC-1066.
Repair or modification must be performed using the same or compatible type lead-free
solder and matching tools. Failure to do so may result in defects caused by dissimilar metals.
Contact factory service for further information.
To Next Page
Loading...
Need help?
General
