ARK-6310 User Manual 48
4.5.2.11 Security Option
Select whether the password is required every time the system boots or only when
you enter setup.
4.5.2.12 APIC Mode
The BIOS supports versions 1.4 of the Intel multiprocessor specification. When
enabled, the MPS Version 1.4 Control for OS can be activated. The choice: Enabled/
Disabled.
4.5.2.13 MPS Version Control For OS
This feature is only applicable to multiprocessor board as it specifies the version of
the Multi-Processor Specification (MPS) that the board will use. The choice: 1.4, 1.1.
4.5.2.14 OS Select for DRAM > 64MB
Select the operating system that is running with greater than 64MB of RAM on the
system.
4.5.2.15 Report No FDD For WIN95
The original Windows95 requires the presence of a floppy. Unless the BIOS tells it to
disregard the absence of the drive, it will generate an error message. For other oper-
ating systems such as Win98, this field is without relevance.
4.5.2.16 Full Screen LOGO Show
This item allows users to enable/disable the full screen logo during the BIOS boot up
process.
Table 4.14: Security Option
Item Description
System The system will not boot and access to Setup will be denied if the
correct password is not entered at the prompt.
Setup The system will boot, but access to Setup will be denied if the cor-
rect password is not entered at the prompt.
Note! To disable security, select PASSWORD SETTING at Main Menu and
then you will be asked to a enter password. Do not type anything and
just press <Enter>, it will disable security. Once the security is disabled,
the system will boot and you can enter Setup freely.
Table 4.15: OS Select for DRAM > 64MB
Item Description
Non-OS2 Disable OS for over 64 MB DRAM
OS2 Enable OS for over 64 MB DRAM
Table 4.16: Report No FDD For WIN95
Item Description
No Don't generate error message
Yes Generate error message
Table 4.17: Full Screen LOGO Show
Item Description
Enabled Full Screen Logo show is enabled
Disabled Full Screen Logo show is disabled
To Next Page
Loading...
Need help?
General
