ARK-6310 User Manual 54
4.5.4.3 Super IO Device
USB Mouse Support
Enabled
Disabled
This item allows you to set the system's
USB Mouse to Enabled/Disabled.
AC97 Audio
Auto
Disabled
This item allows you to decide to Auto/dis-
able the Codec chip to support AC97 Audio.
Table 4.20: Onboard Device
Table 4.21: Super IO Device
Item Options Description
Onboard FDC Controller
Enabled
Disabled
Select Enabled if your system has a floppy
disk controller (FDC) installed on the system
board and you wish to use it. If you are not
going to use FDC or the system has no
floppy drive, select Disabled in this field.
Onboard Serial Port 1
Onboard Serial Port 2
Disable,
3F8/IRQ4
2F8/IRQ3,
3E8/IRQ4
2E8/IRQ3,
AUTO
Select an address and corresponding inter-
rupt for the first and second serial ports.
Onboard Parallel Port
Disabled,
378/IRQ7
278/IRQ5,
3BC/IRQ7
Select a matching address and interrupt for
the physical parallel (printer) port.
Parallel Port Mode
SPP, EPP
ECP, Normal
ECP+EPP
Select an operating mode for the onboard
parallel port. Select Compatible or Extended
unless you are certain both your hardware
and software support EPP or ECP mode.
EPP Mode Select EPP1.9, EPP1.7 Select EPP port type 1.7 or 1.9.
ECP Mode Use DMA 1, 3 Select a DMA channel for the port.
PWRON After PWR-Fail
Off, On,
Former-Sts
This item is to set whether to run Ac Loss
Auto Restart or off
Onboard Serial Port 3
Onboard Serial Port 4
Disable, 3F8
2F8, 3E8, 2E8
Select an IRQ address for the third and forth
serial Ports.