Afinia L901 - Page 42

42 Using the Printer
Afinia
OtherSettings
(continued)
• DisableCOMport
Whenenabled,theprinterwillignoreornottransmit
signalsthroughtheCOMport,whichisusedmainlyfor
debugging.
• DisableInputsensordetectionwhileprinting
Whenenabled,theprinterwillignoretheinputsensor.
UsedtokeeptheprinterfromafalseEORwhen
using
labelstockwithathicklinerthatmakesgaporblack
markdetectiondifficult.
• PrintblankpageaftereveryjobinMultipleJobQueue
Whenenabled,theprinterwillskipalabelatthe
beginningofeachjobinthequeue.
• EnableadvancedEndofRollhandling
Whentheprinter
detectsanEndofRollwhileprinting
Roll‐to‐Rollwithalabelinthecuttermodule,enabling
thisfeaturewi llpausetheprintertoallowtheuserto
releasethemediafromthecoreandprintthelastlabel.
Theuserwillneedtopresstheejectbuttonon
the
controlpanelwhenthisoccurs.
AdvancedSettings2
PrinterPause
Settings
• Pause:Thedurationbetweenprints.
WhentheprinterisinPausemode,theprinterprintsa
labelatthespecifiedtimeinterval.
• PrintandPresent:ThedurationbetweenendofPrint.
andwhentheprintheadismovedtothecappedposition
WhentheprinterisinPrintandPresentmode,
the
printheadwillmovetothecappedpositionata specified
timeafterthelastprint.
• MultipleJobQueue:Allowabletimeoutbetweenjobs.
Whentheprinterissetuptoprintmultiplejobs(withno
cutbetweenjobs),thisvaluespecifiesthemaxallowable
timeforqueuingconsecutivejobsbeforethe
printer
cuts.Thispreventsdamagingtheprintheadresulting
fromprolongeduncappedtime.
• OutofInk:Allowabletimeoutbeforetheprintercutsthe
mediaandcapstheprintheadifacartridgerunsoutof
inkmid‐job.
• EndofJob:Capstheprintheadwhenthejobiscomplete
afterthespecified
time.Note:Extendingthistimecan
reducethelifeoftheprinthead.
Table2EWSpages
EWSPage Description