Afinia L901 - Page 43

L801LabelPrinter
Using the Printer 43
UnwinderSettings • DisableUnwinder
Enablethisoptionwhenusinganexternalunwinder.
• InvertrotationofUnwinder
EnablethisoptionwhenusingFace‐inlabelstock.
• Disablelabellengthcheckwhenloadinganewlabel
stock.
Whenthisoptionisdisabled,theprinterskipsthestepof
checkingthelabellengthof
anewlyloadedlabelstock.
• MinimizeTOFoffsetfor1stLabel
EnablethisoptiononlyifyoufindthattheTOFoffset
(thathappenswiththefirstlabeloftheroll)needstobe
minimizedasmuchaspossible.
MediaGapSetting
•Setinterlabelgapforcontinuousmedia
ClickSubmittoapplythenewvalue.
•Setmaximumgapbetweenlabels
3mm(0.125”)isstandardforGaplabels.Ifyouarenot
usingstandardGaplabels,enterthenewvaluehereand
clickSubmittoapply.
Fine‐tunelinefeed
calibration
• Entermediacorrectionfactor
Fineadjustmentforlinefeed.Enteracompensating
(stretch)factorcalculatedasfollows,
Factor=(PrintedLength÷ImageLength)
*1,000,000
Lengthsareinmillimeters
WiperMaintenance
Schedule
Specifythetimeintervalforthewipertocleanitself.Use
thisoptioniftheprinterisoperatinginadryenvironment
(10%RHorless)wherethewiperrollermaybecomestoo
dryforittoproperlywipeandcleantheprinthead.
CutAfterPrint
Setting
Setthedelaybeforetheprintercutsthelabelafterithas
printedalabel.
PrinterShutdown
Schedule
Shutdowntheprinterdailyataspecifictime.ClickSubmitto
sendtheenteredvaluetotheprinter.
Import/ExportSettings • ImportSettings
Importthe<AdvancedSettings>fromanotherprinter.
• ExportSettings
Exportthe<AdvancedSettings>toanotherprinter.
Table2EWSpages
EWSPage Description