EasyManua.ls Logo

AgfaPhoto OPTIMA 1338mT - Preface

AgfaPhoto OPTIMA 1338mT
71 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Pre
f
ace
About this Manual
This manual is designed to assist you in using your new digital camera. All
information presented is as accurate as possible but is subject to change without
notice.
Copyright
This manual contains proprietary information protected by copyright. All rights are
reserved. No part of this manual may be reproduced by any mechanical, electronic
or other means, in any form, without prior written permission of the manufacturer.
© Copyright 2008
Feder
al
Communications
Commission
(FCC)
Compliance
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
R
eorient or relocate the receivin
g
antenna.
Increase the distance between the equipment and the receiver.
Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Declaration
o
f
Con
f
ormity
This device complies with Part 15 of the FCC rules. Operation is subject to the
following conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference tha
may cause undersired operation.
iv
Warning:
A
shielded-type
power
cord
is
required
in
order
to
meet
FCC
emission
limits
and
to
prevent
interference
to
radio
and
television
reception.
Use
only
shielded
cable
to
connect
I/O
devices
to
this
equipment.
Any
changes
or
modifications
not
expressly
approved
by
the
manufacturer
may
void
your
warranty
and
service
agreement.
Chapter
i:
Preface

Table of Contents

Related product manuals