1100 Series DAD and MWD User Manual 149
Maintenance 8
Replacing the CompactFlash Card
1 Remove the CompactFlash card by pulling it out of its slot in the rear of the
detector.
2 Install the new CompactFlash card into the slot.
3 Turn the detector ON.
When required If defective
Tools required None
Parts required CompactFlash Card Kit 01100-68700
Preparations Turn the detector OFF and have access to the rear of the detector.
NOTE
The detector is equipped with a CompactFlash card. This CompactFlash card is required for
the operation of the detector (data buffering). DO NOT use other types of CompactFlash
cards. Only CompactFlash cards supplied with the detector or as replacement with above
part number are tested with the detector.
Figure 68 Replacing SanDisk CompactFlash card
To Next Page
Loading...
