Agilent Technologies 1100 Series - Agilent Chemstation Setup

1100 Series DAD and MWD User Manual 55
LAN Configuration 3
Agilent ChemStation Setup
1 Start the Configuration Editor of the Agilent ChemStation.
Figure 30 Changing the TCP/IP settings of the Agilent ChemStation
2 Add a TCP/IP connection to communicate with the detector. Use the IP
address of the detector.
Save the configuration, close the Configuration Editor and start the Agilent
ChemStation.
NOTE
If using a corporate LAN, IP addresses need to be supplied by the responsible IT
department. Also the LAN needs to be able to handle additional traffic.