1100 Series DAD and MWD User Manual 85
Using the Detector 4
Special Setups with Multiple DAD/MWDs
Two detectors of same type (e.g. G1315C and G1315C)
If you have two G1315C DADs or G1365C MWD in the same system then you
can rearrange the order in the menu Instrument - Configure 1100 Access to
assign a specific detector as detector 1 and 2.
Two detectors of similar type (e.g. G1315C and G1315A/B)
If you have similar detectors in the same system, the G1315C will be
automatically always detector 2 while the G1315A/B is detector 1 independent
from its location in the stack. This cannot be changed.
NOTE
The diagnostics, tests and OQ/PV should be done with only one detector configured.
To Next Page
Loading...
Need help?
General
