1100 Series DAD and MWD User Manual 155
Parts and Materials for Maintenance 9
Table 21 Maintenance Parts - Overview
Item Description Part Number
1Front cover 5062-8582
2 Control Module G1323B (Note: The G1315C DAD and G1365C can be operated with a G1323B
only. Firmware revision must be B.04.01 or above.)
G1323-67001
CAN cable Agilent 1100 module to control module G1323-81600
3 Flow Cells with ID tag. For details see
“Standard Flow Cell” on page 156,
“Semi-Micro Flow Cell” on page 158,
“High Pressure Flow Cell” on page 160 or
“Nano Flow Cells” on page 162
4 Capillary column – detector 380 mm lg, 0.17 i.d., for details see “Accessory Kit” on page 166 G1315-87311
5 Zero dead volume fitting 5022-6515
6 Flow cell door (seal included)
Screw special for flow cell door
G1315-68707
5022-2112
7 Holmium oxide filter 79880-22711
8 Longlife Deuterium lamp with ID tag (with black cover) (“C“ version) 2140-0820
9 Tungsten lamp G1103-60001
10 Leak funnel 5041-8388
11 Leak funnel holder 5041-8389
12 Clip 5041-8387
13 Corrugated tubing, 120 mm lg, re-order 5 m 5062-2463
14 Teflon Tubing flexible i.d. 0.8 mm (flow cell to waste), see “Accessory Kit” on page 166 5062-2462
Cable CAN to Agilent 1100 Series modules (0.5 m) 5181-1516
Cable CAN to Agilent 1100 Series modules (1 m) 5181-1519
Cross-over network cable (shielded, 3 m long) for point to point connection 5023-0203
Twisted pair network cable (shielded, 7 m long), for hub connections 5023-0202
Analog cable (BNC to general purpose, spade lugs) 01046-60105
CompactFlash Card Kit (Type Sandisk Ultra II) 01100-68700
To Next Page
Loading...
