44 Agilent 7890B Installation
1 Installing the GC
Step 10. Install ALS, if ordered
If installing an ALS, install it now. Refer to its instructions.
Prepare the sampler for checkout. See the checkout procedures
and information in the Operation Manual.
1 Prepare a 2-mL screw-top sample vial.
2 Prepare 4-mL waste vials and place them into the turret.
3 Prepare fresh solvent solutions as needed for the checkout
sample for your detector type. Place the solvent vials into the
injector turret. For details on the solvent needed, see the
Operation Manual:
• FID checkout
• FPD
+
checkout
• FPD
+
checkout (Japan)
• NPD checkout
• TCD checkout
• μECD checkout
To Next Page
Loading...
Need help?
General
