Installing the GC 1
Agilent 7890B Installation 9
Tools and additional parts required
Installation requires the following tools, fittings, and hardware.
These items are not included with the instrument.
• Precleaned copper tubing, 1/8-inch or 1/4-inch od.
• Fittings.
• Tubing cutter.
• Filters for gas supplies.
• 7/16-inch and 9/16-inch wrenches for assembling Swagelok
fittings.
• Carrier and other gas supplies.
• Pressure regulator for each gas supply.
• A computer with a LAN connection (for reading GC
documentation and for updating GC firmware if needed).
• Any additional LAN components, such as cables and a switch
or hub, for connection to the site LAN (not included in
Agilent installation services).
The Agilent GC, GC/MS, and ALS Site Preparation Guide
contains a listing of Agilent installation kits and a description of
parts included with each. These kits contain filters, fittings,
tubing, tools (wrenches, tubing cutter, drivers, and so on), and
other required parts for installing a GC.)
Performing checkout
Checkout requires a system that can produce a chromatogram.
• If using an Agilent data system, you can use it to perform the
checkout procedure. Read these GC installation instructions
and the instructions for installing the data system.
• If an Agilent data system is not available, you can also
perform checkout using the Agilent Instrument Utilities
software. Install the software on a PC, then read its help
topics to learn how to connect to the GC and how to launch
the checkout procedures.
• If connected only to an integrator or site system (for
example, a LIMS system) that captures the GC output signal,
you must connect to that system to obtain the
chromatogram.
System installation
If installing an ALS, the ALS can be used for checkout. Also
To Next Page
Loading...
Need help?
General
